Install the fireplace assembly into the mantel. (refer to mantel
A 15 AMP, 120 VOLT circuit is required. A dedicated circuit is
preferred but not essential in all cases. A dedicated circuit
will be required if after installation the circuit breaker trips or
fuse blows on a regular basis when the heater is operating.
Additional appliances on the same circuit may exceed the
current rating of the circuit breaker.
If not using a Dimplex mantel, the fireplace must be installed
in an enclosure with the following MINIMUM dimensions.
New Wall Construction
1. Although this unit is of zero clearance design, select
a suitable location that is not susceptible to moisture
and is away from drapes, furniture and high traffic.
2. Place the fireplace in the desired location to see how
it will look in the room.
3. Mark the desired location on the floor.
4. Use studs to frame an opening of 26.75" wide X 23"
high X 9" deep.