3.4

Out of 1 Ratings

Owner's of the Dimplex Indoor Fireplace DFG3033 gave it a score of 3.4 out of 5. Here's how the scores stacked up:
  • Reliability

    3.0 out of 5
  • Durability

    3.0 out of 5
  • Maintenance

    2.0 out of 5
  • Performance

    4.0 out of 5
  • Ease of Use

    5.0 out of 5
of 22
 
9
Fireplace Installation
Mark the desired location 3.
on the oor and store the
replace in a safe, dry and
dust free location.
Use studs to frame an 4.
opening of 31 ¾ inches (807
mm) wide x 22 ¾ inches (578
mm) high x 9 ½ inches (241
mm) deep.
Option #1 - The power cord can
be lead from behind the trim and
along the wall to an outlet near
the replace.
Option #2 - A new outlet can be
installed inside the new frame
construction. Plug the unit into
a 15 Amp, 120 Volt outlet. If the
cord does not reach, you may
use an extension cord rated for a
minimum of 1875 Watts.
Option #3 - Hardwire
Wire a dedicated, properly 1.
fused circuit with 120 Volt, 15
Amp rating. Allow up to eight
(8) feet (2.4 m) of service
cable for connecting power
supply to junction box on
replace when installing after
nishing wall.
CAUTION: Use two
conductor, non-metallic sheath
cable with ground wire (three
(3) wires total) for the incoming
power supply on replace inserts.
Use appropriate wire to meet
local and national electrical codes
for rated power consumption.
Remove the outer jacket and 2.
strip the individual conductor
from the end.
Loosen the screw securing 3.
the junction box cover and
remove the cover.
Figure 2
Figure 3