0.5
Owner's of the Taylor Thermometer 532 gave it a score of 0.5 out of 5. Here's how the scores stacked up:
On/Off Operation
1. Place the base unit as close as possible to the remote sensor. This
will ensure easy synchronization between the base and remote.
After set up is complete, keep the units within effective transmis-
sion range (within 200 feet).
2. Turn on the base unit first by press-
ing the On/Off button.The LCD
will turn on and the unit will beep.
3. Turn on the remote unit by pressing the On/Off
button (located on the back).The remote will
vibrate, beep and the “ ” light will blink.
4. Set volume on remote: Off–Low–High. The
volume switch is located on the top of the
remote.
5.The remote will automatically search for a
signal from the base. The remote’s ready light
“ ” will blink, indicating the remote is receiv-
ing a signal from the base.The ready light will
continue to blink every 8 seconds again indi-
cating that the remote is receiving signals from
the base.
6. If transmission is interrupted, the ready light
will stop blinking and the remote will vi-
brate 3 times every 30 seconds.To synchro-
nize the units again, place the base and
remote near each other and press and hold
the “ ” button located on the back of the
base unit.
Press“On/Off”on base unit
Press“On/Off”on remote
2
3
Select volume level
4
Green light =
transmission OK
5
4
No green light &
remote vibrates=
Press“ ” on base
6
Find Your Products By Category
Please Login
